The walls and ceiling are covered with 6.5 mm light grey laminated waterproof plywood.

The floor is covered with 12 mm waterproof rough plywood. The wheel arches are also covered with plywood and designed in a rectangular shape. The rear part of the floor is covered with an aluminum tread plate.

The interior of the workshop is insulated with 22 mm non-absorbent insulation panels.

We installed perforated aluminum side panels on both sides and the front wall to accommodate the attachment of various accessories.

There are load straps on the sides and floor to secure barrels and equipment.

A trash bin and paper roll are conveniently placed near the rear door.

A step is installed at the back of the van to facilitate entry.

We installed various aluminum shelving systems and a worktop from the German manufacturer Aluca. The aerosol bottle holder accommodates at least 8 units.

The workshop is illuminated by two LED strips on the ceiling, with switches near the side door and at the rear of the cargo area. An additional LED light is placed above the worktop.

For outdoor work, there is an LED work light panel installed above both the side and rear doors. The van is equipped with LED signal lights with 9 different flashing modes on the front, rear, and sides.

At the rear door, there is also an air hose reel with a 15-meter hose and an electric cable reel (15+2 m).

The workshop is additionally equipped with the following accessories:

– Inverter 12/230V 700W.

– Piston compressor 2.2 kW 350 l/min 10 bar. Receiver 120 l.

– Electric generator 6.5 kW 230 V.

– Electrical installations for 230V AC and 12V DC with protective devices.

– Ebersprächer D 4 diesel air heater.